A4 Mk3
Sealing flange and drive plate - exploded view |
1 - | Cylinder block |
2 - | Sealing flange with oil seal |
q | Removing and installing → Chapter |
q | Renew only as complete unit |
q | Do not lubricate/grease sealing lip of oil seal |
q | Use support sleeve supplied when fitting |
q | Before installing, remove oil residue from crankshaft journal with a clean cloth |
3 - | Bolt |
q | Tightening sequence → Fig. |
4 - | Drive plate |
q | Lock with counterhold tool -3067- to loosen securing bolts |
5 - | Bolt |
q | 60 Nm + 90° |
q | Renew |
6 - | Needle bearing |
q | Removing and installing needle bearing → Chapter |
7 - | Intermediate plate |
q | Must be positioned on dowel sleeves |
q | Do not damage/bend when assembling |
q | Is fitted onto sealing flange → Fig. |
8 - | Dowel sleeve |
|
|