| –
| Insert counterhold tool -10 - 201- to slacken bolts. |
Caution | Take care not to damage outer surface of bearing flange on drive plate. |
| Use a multi-point socket bit with a length of at least 40 mm to slacken and tighten the drive plate bolts. |
|
| –
| Remove bolts and take off drive plate and sender wheel. |
| Installation is carried out in the reverse order; note the following: |
Note | t
| Renew the bolts tightened with specified tightening angle. |
| t
| A needle bearing is fitted in the drive plate. Before installing, check that the needle bearing is fitted. Removing and installing needle bearing in drive plate (pressing in and out) → Chapter. |
| –
| Pay attention to dowel pin when installing drive plate. |
| –
| Fit counterhold tool -10 - 201- the other way round to tighten bolts. |
|
|
|
