A4 Mk3
| Poly V-belt drive for vehicles with electromechanical power steering - exploded view |
| 1 - | Poly V-belt |
| q | Check for wear |
| q | Before removing, mark direction of rotation with chalk or felt-tip pen |
| q | Removing and installing → Chapter |
| q | Do not kink |
| q | When installing, make sure it is properly seated on pulleys |
| 2 - | Alternator |
| q | Removing and installing → Electrical system; Rep. gr.27 |
| 3 - | Bolt |
| q | Tightening torque → Electrical system; Rep. gr.27 |
| 4 - | Idler roller |
| q | For poly V-belt |
| q | 40 Nm |
| 5 - | Bolt |
| q | Tightening torque → Item |
| 6 - | Poly V-belt pulley |
| q | For coolant pump |
| q | Removing and installing → Chapter „Removing and installing coolant pump“ |
| 7 - | Bolt |
| q | Tightening torque → Item |
| 8 - | Coolant pump |
| q | Removing and installing → Chapter |
| 9 - | Tensioner |
| q | For poly V-belt |
| q | Removing and installing → Chapter |
| q | 40 Nm |
| 10 - | Vibration damper |
| q | With poly V-belt pulley |
| q | Can only be installed in one position (holes are off-set). |
| q | Removing and installing → Chapter |
| 11 - | Bracket |
| q | For air conditioner compressor |
| q | Removing and installing → Rep. gr.87 |
| 12 - | Bolt |
| q | Tightening torque → Rep. gr.87 |
| 13 - | Bolt |
| q | Tightening torque → Rep. gr.87 |
| 14 - | Air conditioner compressor |
| q | Do not unscrew or disconnect refrigerant hoses or pipes. |
| q | Removing and installing → Rep. gr.87 |
| 15 - | Dowel sleeve |
| q | 2x |
| 16 - | Bolt |
| q | Tightening torque → Item |
