A4 Mk3
Oil filter housing, oil pressure switches - exploded view |
1 - | Bolt |
q | 9 Nm |
2 - | Oil filter housing |
q | With map-controlled engine cooling thermostat -F265- |
q | Removing and installing → Chapter |
q | Renew after removing |
3 - | Seal |
q | Permanently attached to oil pressure switch; not available as a replacement part |
4 - | Oil pressure switch -F22- |
q | Opening/closing pressure 2.0 ... 2.5 bar |
q | Green insulation |
q | Checking in Guided Fault Finding → Vehicle diagnostic tester |
q | Removing and installing → Chapter |
q | 20 Nm |
5 - | Seal |
q | Permanently attached to oil pressure switch; not available as a replacement part |
6 - | Oil pressure switch for reduced oil pressure -F378- |
q | Opening/closing pressure 0.75 ... 1.05 bar |
q | Grey insulation |
q | Checking in Guided Fault Finding → Vehicle diagnostic tester |
q | Removing and installing → Chapter |
q | 20 Nm |
7 - | Bolt |
q | Not installed in all vehicles |
q | 4 Nm |
8 - | Retaining clip |
q | For oil filter housing |
q | Not installed in all vehicles |
9 - | Bolt |
q | Not installed in all vehicles |
q | 4 Nm |
10 - | Filler cap |
q | With oil filter bypass valve |
q | 35 Nm |
11 - | O-ring |
q | Renew |
12 - | Oil filter element |
q | Removing and installing → Booklet811, → Booklet812 or → Booklet818 |