audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking fuel pressure senderG247 > < Removing and installing air mass meterG70

A4 Mk3

Removing and installing fuel pressure senderG247
Removing and installing fuel pressure sender -G247-
Special tools and workshop equipment required
   
t  Assembly tool -T10118-
  W00-1148
t  Bit (27 mm) -T40218- or commercially available socket (27 mm)
Removing
–  Carefully pull off engine cover panel.
  WARNING
The fuel system is pressurised. The fuel pressure in the high-pressure part of the injection system must be reduced to a residual pressure prior to opening; for procedure see → Chapter.
  W00-10779
–  Remove bolt -arrow- for coolant line from intake manifold.
  A24-10599
–  Release connector on fuel pressure sender -G247- using assembly tool -T10118-.
–  Unscrew fuel pressure sender -G247- using bit, 27mm -T40218-.
Installing
–  Install in reverse order.
–  Make sure that connecting piece is tightened to specified torque before installing fuel pressure sender -G247-.
l  Tightening torque for connecting piece: Fuel rail - exploded view → Chapter
l  Tightening torque for fuel pressure sender -G247-: Fuel rail - exploded view → Chapter
  A24-10445

Checking fuel pressure senderG247 > < Removing and installing air mass meterG70