Audi Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
4-cylinder TDI engine (2.0 ltr. 4-valve common rail), mechanics >
< Removing and installing engine speed senderG28
A4 Mk3
Power unit
TDI injection and glow plug system (4-cyl. 2.0 ltr. 4-valve common rail)
Ignition system, glow plug system / Checking glow plug system
Removing and installing Hall senderG40
Removing and installing Hall senderG40
Removing and installing Hall sender -G40-
–
Remove poly V-belt
→ Rep. gr.13
.
–
Remove toothed belt
→ Rep. gr.15
.
–
Remove vibration damper
→ Rep. gr.13
.
–
Unplug electrical connector for Hall sender -G40-
-arrow-
.
–
Release connector from its retainer.
–
Unbolt Hall sender -G40-
-arrow-
.
–
Using a screwdriver, remove projections and take out cover for repair opening
-arrows-
.
–
Take Hall sender -G40- off cylinder head and guide its connector through repair opening in toothed belt cover.
Installing
Install in reverse order. Note the following:
t
Seal repair opening in toothed belt cover with rubber plug; for rubber plug refer to
→ ETKA (Electronic parts catalogue)
.
–
Fit toothed belt and adjust valve timing
→ Rep. gr.15
.
Power unit
TDI injection and glow plug system (4-cyl. 2.0 ltr. 4-valve common rail)
Ignition system, glow plug system / Checking glow plug system
Removing and installing Hall senderG40
4-cylinder TDI engine (2.0 ltr. 4-valve common rail), mechanics >
< Removing and installing engine speed senderG28