Audi Workshop Service and Repair Manuals

Exploded view of pipes and hoses (vehicles with 4-cylinder diesel engine, vehicles with and without dynamic steering)

Exploded view of mounting parts for pipes and hoses 1 -  Bracket for reservoir to body → Fig. 2 -  Reservoir in bracket → Fig. 3 -  Bolt in bracket → Fig. 4 -  Clip for securing return hose to longitudinal member → Fig. and clip for securing suction hose to pressure pipe → Fig. 5 -  Hydraulic fluid cooler to condenser → Fig. 6 -  Power steering pump in bracket → Chapter „Removing and installing power steering pump (vehicles with 4-cylinder diesel engine, vehicles with dynamic steering)“ or → Chapter „Removing and installing power steering pump (vehicles with 4-cylinder diesel engine, vehicles without dynamic steering)“ 7 -  Pressure line to cross brace → Fig. 8 -  Installation position of pressure line connection → Fig. 9 -  Pressure line to engine mounting → Fig. 10 -  Return line to subframe → Fig., return line bracket to longitudinal member → Fig.

Bracket for reservoir to body –  Secure bracket -2- to body with bolts -1-. –  Secure reservoir -4- in bracket -2- with bolt -3-.

Reservoir in bracket –  Fit reservoir (insert lug -1- into recess in bracket -2-).

Clip for securing return hose to longitudinal member –  Attach return hose -1- to longitudinal member (left-side) using clip -2-.

Suction hose in clip of pressure pipe –  Insert suction hose -1- in clip -2- of pressure pipe -3-.

Hydraulic fluid cooler to condenser –  Position hydraulic fluid cooler -1- on retainers -2- and then engage in retainers -3-. Hoses to hydraulic fluid cooler → Chapter

Pressure line to cross brace –  Bolt pressure line with nut -3- and rubber mounting -4- onto cross brace. –  Note correct position of line when connecting. Markings -1- and -2- must be aligned.

Pressure line to engine mounting –  Route pressure line -4- between connecting element -2- and engine mounting -3-. –  Screw retainer -5- to stud -1- with nut -6-.

Retainer for securing return line to subframe –  Secure retainer -1- of return line to front left of subframe -2-.

Return line to subframe –  Attach return line -4- with bracket -2- and bolt -1- to subframe -3-.