audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing washer fluid reservoir > < Removing and installing washer jet

A4 Mk3

Adjusting washer jet
Adjusting washer jet
Special tools and workshop equipment required
   
t  Adjusting tool for washer jet -T40187- fitted with needle -3125/5A-
  W00-10848
Procedure
  WARNING
Risk of injury.
t  When the adjusting tool for washer jet -T40187- is not used, make sure both sides are always covered and secured with the covers -3- and -4-.
t  If one side is not secured with the cover, injuries may be caused by the needle -3125/5A--item 1- or the adjusting pin -2-.
t  When opening one of the sides, always make sure the opposite side does not point towards your hand.
  A92-10197
–  Release short cover -1- on adjusting tool for windscreen spray jet -T40187--arrow A- and slide towards rear -arrow B-.
  A92-10203
–  Adjust washer jets using adjusting tool -T40187- so that water jets spray rear window at points indicated.
l  Dimension -a- = 150 mm
l  Dimension -b- = 10 mm
l  Dimension -c- = 300 mm
–  If spray pattern does not match specifications, clean the contaminated washer jet.
  WARNING
Risk of injury.
The adjusting pin must be covered and secured with the cover each time it has been used.
Cleaning washer jet:
–  Remove washer jet → Chapter.
–  Rinse washer jet with clear water in opposite direction of spray.
–  Always blow through washer jet in opposite direction of spray when removing remaining particles of dirt by applying compressed air.
–  If spray pattern still does not match specifications, renew the washer jet.
  A92-10133

Removing and installing washer fluid reservoir > < Removing and installing washer jet