audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing wiper motorV with wiper motor control unitJ400 > < Adjusting wiper arms

A4 Mk3

Removing and installing wiper motorV with wiper motor control unitJ400
Removing and installing wiper motor -V- with wiper motor control unit -J400-
Special tools and workshop equipment required
   
t  Removal lever -80 - 200-
  W00-0353
Removing
–  Remove wiper arms → Chapter.
Vehicles up to 05.2008:
–  Detach seal -arrow-.
–  Unclip plenum chamber covers -1 ... 3- and detach.
  A92-10115
Vehicles from 06.2008 onwards:
–  Remove bolts -3-.
–  Unclip retaining clips -2- from retainer and detach plenum chamber cover -1-.
  A92-10166
All vehicles (continued):
–  Pull off retaining clips -2--arrow A-.
  Caution
Risk of damage to cowl panel trim.
Apply a small quantity of soap solution to the transition between the windscreen and cowl panel trim. Then, starting at the edge of windscreen, carefully pull the cowl panel trim -1- vertically up and out of retainer at windscreen -arrows B-.
–  Detach cowl panel trim -1-. To do so, carefully pull cowl panel trim off retainer at windscreen -arrows B-.
  A92-10086
–  Unplug electrical connector -2- and move clear.
–  Pull water drain channel -3- off linkage -arrow A-.
–  Remove bolts -4, 5, 6-.
–  Rotate wiper frame -1- upwards -arrow B- together with linkage and wiper motor, and remove from plenum chamber towards front of vehicle.
Installing
l  Tightening torque → Fig.
Installation is carried out in the reverse order; note the following:
–  Fit wiper motor with wiper frame in vehicle.
–  Tighten bolts → Fig..
–  Attach water drain channel to wiper motor.
–  Adjust wiper arms → Chapter.
  A92-10075

Renewing wiper motorV with wiper motor control unitJ400 > < Adjusting wiper arms