A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
3 - Bleeder valve, 10 Nm
‹› Apply a thin coat of lithium grease (G 052 150 A2) before installing
4 - Protective cap
‹› Push onto the bleeder valve
5 - Brake caliper housing
6 - Retaining spring
‹› Insert with both ends in the holes in brake caliper housing
‹› After inserting the retaining spring into the two holes, press it under the brake carrier. If incorrectly installed, it is not possible to adjust the wear of
the outer pad, and the pedal travel will be increased as a result.
7 - Bushing
‹› Insert into the brake caliper housing
8 - Brake carrier
‹› Bolts to brake caliper housing
9 - Seal
10 - Piston
‹› Apply a thin coat of lithium grease (G 052 150 A2) to the piston before inserting
11 - Protective cap
‹› Do not damage when inserting the piston