A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
/Page-779004.png)
‹› If pin does not fit into notch: Remove chain and place chain on again.
-
Tighten camshaft adjuster screw. To do so, use socket insert (T40080).
-
Remove Locking Pin (T10115) - arrow B -.
The rest of assembly is basically a reverse of disassembling sequence.
-
Install intake manifold.
-
Install high pressure pump.
-
Install vacuum pump.
Tightening Specifications
Cylinder head, camshafts. Refer to => [ Cylinder Head, Camshafts Assembly Overview ] See: Camshaft, Lifters and Push Rods/Camshaft/Service and
Repair/Cylinder Head, Camshafts Assembly Overview
Cylinder head, assembly overview. Refer to => [ Cylinder Head Assembly Overview ] See: Cylinder Head Assembly/Service and Repair/Cylinder
Head Assembly Overview
