A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
‹› Tightening specification 35 Nm
‹› A plastic washer may be glued on, depending on time period of production. Refer to => [ Compressor Belt Pulley, Version 2 ] See: .
3 - Circlip
‹› Replace
‹› Install on proper side (level side to compressor)
‹› Removing and installing, refer to => [ Compressor Belt Pulley, Version 2 ] See:
4 - Spacer
‹› Dimensions: 17.5 x 10 x 3 mm
5 - Rubber element
‹› Qty. 6, install on proper side. Refer to => [ Compressor Belt Pulley, Version 2 ] See:
‹› Decouples belt pulley from compressor driveshaft, damps vibrations and noise.
‹› for installation, lightly coat rubber elements, e.g. with tire mounting paste or a soap solution (as a lubricant)
6 - Belt pulley
‹› Belt pulley is made of plastic and is sensitive to impact, therefore handle it with especial care
‹› Different versions.
‹› Removing and installing, refer to => [ Compressor Belt Pulley, Version 2 ] See:
7 - Compressor
‹› Different versions are installed, depending on engine version and country version of vehicle.
‹› Clean compressor flange before sliding on pulley.