A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
‹› Removal:
-
Remove rear bench seat. Refer to through October 2004 => [ Bench Seat, through October 2004 ] See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Rear Seats; from November 2004 => [ Bench Seat, from November 2004 ] See: Body and Frame/Seats/Service
and Repair/Removal and Replacement/Rear Seats.
-
Remove bolts - 7 -.
-
Remove 2/3 rear seat backrest. Refer to => [ Right 2/3 Backrest ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seats.
-
Press cover with belt guide cover - 6 - to side and pry retaining tab - 11 - out with a screwdriver.
-
Remove cover - 6 - in direction of arrow - A -.
-
Remove 2/3 rear seat backrest upholstery until you can remove anchor with upholstery.
-
Remove bolt - 1 - (Qty. 1).
-
To disconnect harness connector - 9 -, open retainer using a screwdriver (USA).
-
Remove nut - 2 - (Qty. 1).
-
Remove third rear three-point seat belt - 3 -.
‹› Installing:
-
To install belt guide cover - 6 -, retaining tab - 10 - must first be positioned and inserted, then retaining tab - 11 - must be rotated inward while
panel - 12 - is guided into cut-out - 13 - on belt guide cover - 6 - - arrow B - (magnified area).