A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
‹› The cushion is included as part of the service kit.
‹› Clip - 4 - must not be separated.
‹› The hard foam insert in the crease is not included in the service kit.
-
Remove clips - 2 - and - 3 - (Qty. 2).
-
Carefully pull seat occupied recognition mat - 1 - with cushion - 5 - upward while guiding Seat Occupied Recognition Pressure Sensor (G452) and
Seat Occupied Recognition Control Module (J706) through seat pan without disconnecting connectors.
-
Remove the complete service kit.
CAUTION!
The pressure hose and the Seat Occupied Recognition Mat - 1 - must not be kinked under any circumstances during repairs.
Service Kit, Installing
CAUTION!
Observe the safety precautions for repairs on airbags. Refer to => [ Airbag System General Safety Precautions ] See: Air Bag
Systems/Air Bag/Service Precautions/Airbag Safety Precautions, side airbags => [ Side Airbag Safety Precautions ] See: Air Bag
Systems/Air Bag/Service Precautions/Airbag Safety Precautions and the seat occupied recognition system => [ Passenger Occupant
Detection Sensor Safety Precautions ] See: Air Bag Systems/Air Bag/Service Precautions/Airbag Safety Precautions and => [ Passenger
Occupant Detection System, Measures Required after an Accident ] See: Air Bag Systems/Air Bag/Service Precautions/Airbag Safety
Precautions.
‹› The hard foam insert in the crease is not included in the service kit. Therefore, reuse the hard foam insert again in the seat crease.
-
Guide Seat Occupied Recognition Pressure Sensor ( G452) and Seat Occupied Recognition Control Module (J706) from above through seat pan
without disconnecting connectors.
-
Pull the crease between seat pan and Seat Occupied Recognition Mat - 1 - so that it is smooth (free of folds).