A4 Quattro Cabriolet L4-2.0L Turbo (BWT) (2009)
/Page-327002.png)
-
Switch the ignition on.
-
Using a Multimeter, check the Fuel Pressure Sensor (G247) electrical harness connector terminals for voltage.
-
Switch the ignition off.
If the specified value was obtained:
-
Replace the Fuel Pressure Sensor (G247). Refer to Fuel Injection and Ignition Repair Information
If the specified value was not obtained:
Checking wiring connections
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. Refer to Fuel Injection and Ignition Repair Information
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Powertrain Management/Computers
and Control Systems/Engine Control Module/Service and Repair.
