A4 Quattro Cabriolet V6-3.0L (BGN) (2005)
/Page-493001.png)
Crankshaft Main Bearing: Specifications
Crankshaft
Main Bearing caps
-Replace bolts -A- and nuts -1- to -8-.
Tighten bearing cap nuts or bolts in following sequence:
1. - Screw in bolts -A- hand tight.
2. - Tighten nuts -1- to -8- ............................................................................................................................................................................... 35 Nm
3. - Tighten nuts -1- to -8- ......................................................................................................................... 90° (1/4 turn) further using rigid wrench.
4. - tighten bolts -A- to ..................................................................................................................................................................................... 20 Nm
5. - Tighten bolts -A- ................................................................................................................................. 90° (1/4 turn) further using rigid wrench.
Number markings on crankshaft bearing cap
^
Bearing 1 is located on the belt pulley side
