A4 Quattro Cabriolet V6-3.0L (BGN) (2005)
/Page-571001.png)
Intake Manifold: Service and Repair
Intake Manifold, Removing and Installing
Intake manifold, removing and installing
CAUTION: Before beginning repairs on the electrical system:
^
Obtain the anti-theft radio security code.
^
Switch the ignition off.
^
Disconnect the battery Ground (GND) strap.
^
On vehicles equipped with Audi Telematics by OnStar, switch-off the emergency (back-up) battery for the Telematic/Telephone Control Module
prior to disconnecting vehicle battery.
^
After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows.
^
After reconnecting vehicle battery on vehicles equipped with Audi Telematics by OnStar, switch-on the emergency (back-up) battery for the
Telematic/Telephone Control Module.
Removing
Note: All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
-
Drain coolant.
WARNING: Observe safety precautions when disconnecting the battery.
See Caution before beginning repairs on the electrical system
-
Switch ignition off and disconnect battery Ground (GND) strap.
-
Remove rear engine cover (arrows).
-
Remove front engine cover (arrows).
