A4 Quattro Cabriolet V6-3.0L (BGN) (2005)
/Page-387004.png)
‹› The ATF inspection plug must be screwed in again before the ATF reaches a temperature of 45 °C (for hot countries 50 °C).
Add ATF if no ATF has escaped from the ATF inspection plug hole by 45 °C.
-
Tighten ATF inspection plug with a new gasket to 80 Nm. The ATF check is now completed.
-
End the "OBD", switch off the ignition and unplug diagnostic connector.
Filling ATF
If no ATF escapes at the ATF inspection opening at 40 °C, ATF must be topped off;
‹› The ATF inspection plug must be screwed in again before the ATF reaches a temperature of 45 °C (for hot countries 50 °C). Allow transmission to
cool and check again.
-
Guide filler hook of ATF Filler Tool (V.A.G 1924 ) into an opening - arrow - of protective cap, do not push cap up and in while doing so.
-
Add ATF using ATF Filler Tool (V.A.G 1924) until ATF drips from the inspection opening.
‹› If the ATF level is too high or too low it will adversely affect the operation of the transmission.
-
Fasten ATF inspection plug with new gasket to 80 Nm.
-
End the "OBD", switch off the ignition and unplug diagnostic connector.
