A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper (RS4) - Assembly Overview
Front bumper (RS4)-assembly overview
NOTE:
-
Removal and installation is done the same as the standard bumper from model year 2006.
-
Only differing steps are described.
1
-
Screw
-
6 Nm
2
-
Bumper cover
-
Removal and installation as with standard production.
NOTE: While installing, the following sequence described for assembling/bolting must be observed for correct assembly.
-
Set cover onto vehicle and first clip the left and right side piece into guide parts - 10 -.
-
Tighten nuts on fender connection.
-
Tighten bolts - 12 - to wheelhousing liner.
-
Loosely thread in bolts - 1 -.
-
Close hood and check cover for projection and recess.
-
If necessary, check position of cover and tighten bolts - 4 -.
-
Tighten bolt on support piece to 2 Nm.
-
Bumper cover, removing and installing.
-
Crossmember, removing and installing.
3
-
Guide piece
4
-
Screw
-
1 Nm
5
-
Brace for fender
6
-
Bumper crossmember
7
-
Support piece