A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Position engine/transmission jack VAG 1383 A with universal transmission support VAG 1359/2 and a suitable wooden block at subframe/final
drive (illustration shows vehicle with front wheel drive).
-
Tighten belt around subframe/final drive.
Note:
^
If a front hydro-bushing is being replaced, only loosen the front subframe bolts.
^
If a rear hydro-bushing is being replaced, only loosen the rear subframe bolts.
^
If a further subframe bolt is loosened (front or rear), a wheel alignment must be performed following installation.
-
Loosen front or rear subframe bolts.
-
Carefully lower subframe approx 5 cm.
-
Only remove those subframe bolts where the hydro-bushing is to be replaced.
-
Using felt pen or similar, mark Position of hydro-bushing - 1 - in relation to subframe - 2 - (illustration shows subframe of a front wheel drive
vehicle).
- Arrow A - : direction of travel
- Arrows B and C -: markings
-
Apply special tools as shown in illustration.
1 - Nut T40034/1 or T40034/2
2 - Thrust piece T40033/1
3 - Support ring T40033/2
4 - Tube T40033/3