A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Control Systems/Engine Control Module/Service and Repair/ECM, Removing and Installing.
-
Install the drivers side storage compartment. Refer to Fuel Injection and Ignition Repair Information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. => [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 03 - Read DTC Memory.
2. If necessary, erase the DTC memory. => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory.
3. If the DTC memory was erased, generate readiness code. => [ Readiness Code ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
-
End of diagnosis.