A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-188003.png)
‹› The Engine Control Module (ECM) (J623) remains connected at the wiring harnesses.
CAUTION!
To prevent damage (burning) to wire and harness connections, insulation and control modules, perform the following work steps exactly!
Observe operating instructions for heat gun.
‹› The threads in the protective housing, into which the shear bolts are threaded, are then heated with the heat gun. During this step, the holding
effect that the locking compound has on the shear bolt threads is reduced, thereby allowing the shear bolts to be removed easier.
-
Using a Heat gun set at its lowest setting, heat the shear bolt for approx. 20 to 25 seconds.
-
Remove the shear bolt with locking pliers. Discard the used shear bolts.
Repeat the previous steps for the second shear bolt.
