A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Battery: Removal and Replacement
Battery
Battery
Removing
CAUTION!
For vehicles with Telematics, activate service mode of Telematics control module before disconnecting the battery.
-
On vehicles with coded radio control module/radio navigation system (only other manufacturers), note code, obtain if necessary.
-
Switch off ignition.
-
Remove plenum chamber cover rubber seal in - direction of arrow -.
-
Remove plenum chamber cover - 1 - forward.
-
Connect the battery charger for battery assistance mode. Refer to => [ Battery, Preparing for Support Mode ] See: Procedures/Battery, Preparing
for Support Mode.
-
Loosen nut several turns and remove ground wire terminal clamp - 1 - from battery terminal.
-
Loosen nut several turns and remove ground wire terminal clamp - 2 - from battery positive terminal.
-
Remove the bolt - 4 - with a ball head hex socket wrench just far enough until the ball head rubs against the strut tower.
-
Let hex bolt and securing bracket - 3 - remain installed and swing out battery under securing bracket.