A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Clutch Switch: Service and Repair
Clutch Pedal Switch F36, Removing and Installing
Clutch pedal switch F36, removing and installing, 02X, 6-Speed Four-Wheel Drive M/T
Note:
^
Clutch pedal switch may only be installed once so as to ensure a secure fit.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 1 - on clutch pedal switch.
^
The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod arrow - of clutch pedal switch should then rest against
clutch pedal.
-
Release clutch pedal switch - 2 - by turning 45° counter-clockwise and remove from guide.
Installing
Installation is in reverse order of removal. Note the following:
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch.
^
The clutch pedal should be in the normal position (i.e. not pressed down).
-
Guide clutch pedal switch through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
-
Connect connector for clutch pedal switch.
-
Install storage compartment on drivers side.