A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
^
Thrust piece T40033/5
^
Support T40033/6
^
Spindle T40034
^
Nut T40034/1
^
Nut T40034/2
Note:
^
The same special tools and workshop equipment can be used for replacing the subframe bushings on vehicles with front wheel drive and vehicles
with all wheel drive.
^
The subframe bushings are hydro-bushings, not conventional bonded rubber bushings
^
The bushings can only be removed and installed with the subframe lowered.
^
Mark position of bushings in relation to subframe before removing.
Removing front/rear hydro-bushings
-
Remove wheels.
-
Remove left and right coil springs.
-
Only if front hydro-bushing is being replaced: remove rear left/right floor pan panels
1 - Left-side floor pan panel
-
If installed, remove diagonal braces - 1 - and - 2 -.
Only for rear hydro-bushings
-
Remove stabilizer bar.
Front and rear hydro-bushings, continued