A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
1
Bell E-40
2
Hollow piston cylinder HKZ-15
3
Special nut E-8-214 and tie bolt
Wheel bearing, pulling out
-
Attach pressure piece - 1 - with collar to bearing, pressure sleeve - 2 - with four tiered interior diameters to wheel bearing housing, hollow piston
cylinder - 3 - with tie bolt and special nut - 4 -.
-
Operate pump and remove the wheel bearing.
1
Thrust piece E-5
2
Thrust sleeve E-44-1
3
Hollow piston cylinder HKZ-15
4
Special nut E-8-214 and tie bolt
Wheel bearing, pressing in
Installation position: Larger internal diameter of wheel bearing faces outward.
-
Put wheel bearing - 1 -, pressure piece - 2 - (put collar into bearing), and hollow piston cylinder - 3 - with tie bolt on wheel bearing housing.
-
Attach pressure piece - 4 - with angles toward wheel bearing housing and special nut - 5 - from inside.
-
Press wheel bearing in by operating the pump.
1
Wheel bearing
2
Thrust piece E-14-1