A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Remove flange shaft by placing a chisel or spacer piece - A - under the flange shaft and by turning bolt - B -.
‹› If difficult to remove, rotate flange shaft and screw bolt into the opposite threaded hole for removal of flange shaft.
-
Replace flange shaft circlip.
-
Clamp flange shaft in vise, using jaw protectors. Press circlip with new circlip - A - out of flanged shaft groove.
Installing
Install in reverse order, paying attention to the following:
-
Clean flange shaft and shaft seal.
-
A damaged sealing ring must be replaced. Refer to => [ Right Flange Shaft Seal ] See: Seals and Gaskets/Service and Repair/Final Drive,
Differential (09LA Transmission)/Right Flange Shaft Seal.
-
Fill area between sealing lip and dust lip halfway with sealing grease (G 052 128 A1).
-
Insert flange shaft by hand into splines of differential until splines lock properly into place.
-
Press flange shaft in by hand or with needle bearing drift (VW 295) as far as the stop.
‹› The circlip of flange shaft must be engaged.
-
Fasten right drive axle to the flange shaft.
-
Check oil level in front final drive.
Tightening Specifications