A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Assembling
-
Make sure that selector lever is still in position "S".
-
Swivel locking lever - 11 - upward as far as it will go.
-
Insert selector lever - 6 - into selector lever housing - 14 - from below.
-
Install Tiptronic locking levers - 4 - and - 18 -, and bushings - 3 - and - 15 - onto selector lever.
-
Push selector lever - 6 - together with bushings into selector lever housing - 14 - and position with retaining clip - 17 -.
-
Engage retaining clips - 2 - and - 16 - on selector lever housing.
-
Press pivot pins - 5 - and - 19 - into selector lever - 6 - until they engage.
-
Check that the pivot pins are engaged in the Tiptronic locking lever.
-
Install Shift lock solenoid N110 - item 7 -.
-
Clip selector gate - 12 - onto selector housing - 14 - and tighten to 0.4 Nm.
Removing and installing securing spring for locking cable
Removing
-
To remove locking cable lift spring slightly at top - arrow B -.
-
Disengage spring from retainer lug - arrow C - and lift out.
Installing
-
Insert spring from above - arrow B - and engage under retainer lug - arrow C -.
-
Align spring so that it lies level in groove - arrow A -.