A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Note: If the tab on the reverse side of the wiring harness breaks off, the wiring harness must be replaced.
-
Install wiring harness connector in transmission housing.
^
Installation position: flat part of rear shoulder faces downward, the lugs at shoulder are horizontal
-
While installing mechatronics unit without force, insert transmission selector lever stud - arrow - into groove on selector slide - A - (move selector
slide backward and forward if necessary).
-
Tighten securing bolts - 1 - and - 2 - for mechatronics unit to 2 Nm.
-
Then tighten securing bolts in specified sequence - 1 to 11 - to 8 Nm.
-
Push retainer clip - arrow - onto wiring harness connector.
-
Install ATF strainer.
-
Install oil pan.
-
Follow steps required after connecting battery.
-
Fill with ATF.