A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1841001.png)
Clutch Disc: Removal and Replacement
Self-Adjusting Clutch (Sachs Version), Servicing
Self-adjusting clutch (Sachs version), servicing, 02X, 6-Speed Four-Wheel Drive M/T
CAUTION!
On this type of clutch the pressure plate and clutch plate can only be replaced together.
^
Identification
^
Select correct clutch plate and pressure plate according to engine code.
1 - Bolt -22 Nm-
2 - Pressure plate
^
Self-adjusting
^
Identification
^
Pressure plate and clutch plate can only be replaced together.
^
Check ends of diaphragm spring
^
Check spring connection and rivets
^
Check wire ring
3 - Clutch plate
^
Pressure plate and clutch plate can only be replaced together.
^
Installation position: Clutch lining must make full contact with flywheel
^
The marking "Getriebeseite" (transmission side), if provided, faces pressure plate/transmission.
^
If installed, coil springs (damper assembly) face pressure plate and transmission
^
Centralize
4 - Bolt for flywheel
^
Always replace
^
Observe instructions for removal
^
Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^
Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn
