A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1846010.png)
-
Over-center spring, installing => [ Installing ] See: Clutch Pedal Assembly/Service and Repair/Removal and Replacement/02XA
Transmission/Over-Center Spring.
-
Install storage compartment on driver side.
-
Bleed clutch system. Refer to => [ Clutch System, Bleeding ] See: Service and Repair/Procedures/02XA Transmission.
-
Insert E-box and tighten the nuts - arrow - to 4 Nm.
-
Route engine wiring harness and connect connector in connector station.
-
Install Engine Control Module (ECM).
-
Install additional relay carrier or additional fuse holder, if necessary.
-
Press in cap by hand and tighten bolts in diagonal sequence to 4 Nm.
-
Observe procedures for connecting battery.
