A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Pull out needle bearing using internal puller Kukko 21/2 and counter-support Kukko 22/1.
Note:
^
The plastic ring in the dual-mass flywheel is affected by impacts. If plastic ring is damaged, the dual-mass flywheel must be replaced.
-
Drive needle bearing into dual-mass flywheel using bearing driver 3264.
-
Using backside of centering mandrel 3176, press needle bearing further in until previously measured depth is achieved.
-
Afterwards, verify depth - dimension x - that the needle bearing is driven into dual-mass flywheel.
-
Install clutch pressure plate.
-
Install transmission.