A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1873001.png)
Pressure Plate: Removal and Replacement
Clutch With SAC Pressure Plate (LuK Version), Servicing
Clutch with SAC pressure plate (LuK version), servicing, 02X, 6-Speed Four-Wheel Drive M/T
^
Please refer to notes go to Clutch, servicing
^
Remove transmission to work on clutch.
Note:
^
"SAC" stands for "Self-Adjusting Clutch".
1 - Dual-mass flywheel
^
Ensure that dowel pins fit tightly
^
Contact surface for clutch lining must be free of grooves, oil and grease
^
Observe instructions for removal
2 - Needle bearing
3 - Bolt for flywheel
^
Always replace
^
Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^
Bolt length: 43 mm; 60 Nm plus an additional 180° 1/4 turn
^
Observe instructions for removal
4 - Clutch plate
^
Installation position: Clutch lining must make full contact with flywheel
^
The marking "Getriebeseite" (if provided) faces pressure plate/transmission.
^
Coil springs (damper assembly) point toward pressure plate and transmission
^
Centralize
5 - SAC pressure plate
^
Check ends of diaphragm spring
^
Check that pressure plate is not warped
^
Check spring connection and rivets
