A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
2 - Circlip
^
Use commercially available circlip pliers when removing and installing
^
Always replace
3 - Inner constant velocity joint with cap for boot
^
Outside diameter: 108 mm
^
Replace only as a complete assembly
^
Pressing off
^
Pressing on
^
Greasing
^
Adhesive surfaces must be free of oil and grease
4 - Lock plate
5 - Socket-head bolt
^
Tightening torques:
^
M8 bolt: 40 Nm
^
M10 bolt: 65 Nm
6 - Clamp
^
Always replace
^
Tightening
7 - Boot for inner constant velocity joint
^
With vent hole
^
Check for tears and chafing, replace if necessary
^
If damaged, check inner constant velocity joint
^
Sealing surfaces of boot to drive axle/cap must be free of grease during assembly
8 - Drive axle
9 - Boot for outer constant velocity joint
^
Outside diameter: 88 mm
^
Without vent hole
^
Check for tears and chafing, replace if necessary
^
If damaged, check outer constant velocity joint
^
Sealing surfaces of boot to drive axle/cap must be free of grease during assembly
10 - Clamp
^
Always replace
^
Tightening
11 - Circlip
^
Always replace
^
Insert in shaft groove
12 - Outer constant velocity joint
^
Replace only as a complete assembly
^
Driving off
^
Installing: drive onto shaft with plastic hammer until compressed circlip seats
^
Circlip must fit in chamfer on joint when installing; guide with pliers if necessary.
^
Greasing
13 - Collared bolt
^
Always replace