A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
-
Secure drive axle with protective covers in vise clamp.
-
Remove large clamping sleeve and turn back protective joint boot.
-
Strike a copper or brass drift on CV joint inner race with a hammer
Venting CV boot
Only for joint protective boot of rubber
A vacuum can form in the joint when installing the protective joint boot.
This pressure pulls a fold in while driving see - arrow -.
Therefore, observe the following:
-
Before clamping sleeves, balance pressure by raising protective joint boot.
Location of spacer and spring washer (wheel side)