A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
Seals and Gaskets: Removal and Replacement
Flange Shaft Seal and Ball Bearing, Replacing
Flange Shaft Seal and Ball Bearing, Replacing
Remove the center differential housing - A - (transmission installed). Refer to => [ Self-Locking Center Differential, Transmission Installed ] See:
Differential/Service and Repair/Overhaul/Differential, Manual Transaxle/Self-Locking Center Differential, Transmission Installed.
Remove the center differential housing - A - (transmission removed). Refer to => [ Transmission, Assembly Sequence ] See: Service and
Repair/Overhaul/02XA Transmission/Transmission, Assembly Sequence.
Pressing out flange shaft
-
Remove the circlip before remove the flange shaft. Refer to => [ Circlip Installation Positions and ].
-
Position the center differential housing so the flange shaft does not come into contact with the Thrust Pieces (VW 401) and (VW 402) when
pressing it off.
Pressing in flange shaft