A4 Quattro Cabriolet V6-3.2L (BKH) (2007)
/Page-1910002.png)
-
Check whether there is a factory marking (paint dot) on drive shaft. If you do not find one, mark the position of the constant velocity joint -arrow
A- relative to the rear final drive -arrow B-with a colored dot.
-
Disconnect drive shaft from rear final drive and tie it up to exhaust system brackets.
-
Place engine/transmission jack VAG 1383 A with universal transmission mounting 1359/2 under final drive and secure final drive.
-
Remove securing bolts -arrows- of left final drive support.
-
Carefully lower final drive until flange is freely accessible.
-
Color-mark the position of the securing nut for the drive pinion.
Calculate dimension "a" and dimension "b"
^
Distance of flange to drive pinion =
Dimension a
^
Distance of flange to securing nut for the drive pinion =
Dimension b
-
Note calculated dimensions
-
Count turns when unscrewing the securing nut and make a note of them.
