A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
-
Position pin -A- in notch -B-.
Fig. 4 Checking clutch gap
-
Using depth gauge -C-, measure gap between top of clutch plate and belt pulley at three equally spaced locations. Note this dimension.
-
Energize clutch coil by applying DC 12 V to single connector -A- (compressor -B- must be grounded).
-
With clutch energized, note second reference dimension between top of clutch plate and belt pulley.
Difference between the two gap dimensions must be: 0.4 to 0.6 mm (0.014 - 0.024 in.).
-
If necessary, adjust gap by removing clutch plate and adding or removing shims.
NOTE:
-
Gap must be within tolerance around entire circumference.
-
Gap can be checked with compressor installed.