A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
-
Secure side curtain airbag at grab handle adapters -2- (2x) using pre-assembly clips See Fig. 5
-
Clip igniter -5- in at clip -7-.
-
Install bolts -8- (2x) See Fig.1.
-
Release front portion of airbag -1- and fold it back to A-pillar, during this, twist-securing seam -A- must face center of vehicle.
-
Clip in side curtain airbag using clip -3-.
-
Install bolt -4- See Fig. 3.
-
Remainder of installation is in reverse order of removal
-
Switch ignition on.
WARNING!
Make sure the passenger compartment is not occupied before connecting the battery Ground (GND) strap.
-
Connect battery.
2
-
Grip handle adapter
3
-
Clip
4
-
Bolts (2x)
-
4 Nm (35 in. lb)
-
Self-locking
-
Always replace
-
Always clean threaded holes for drive flange bolts (e.g. using tap)
5
-
Igniter
6
-
Side curtain airbag harness connector
7
-
Clip
8
-
Bolts (2x)
-
4 Nm (35 in. lb)
-
Self-locking
-
Always replace
-
Always clean threaded holes for drive flange bolts(e.g. using tap)
-
Use VAS 5122 and VAG 1783
Fig. 1 Igniter at D-pillar
-
Engage clip -7- in mount -A-.
-
Install bolts -8-.
-
Tightening torque: 4 Nm (35 in. lb)
-
Use VAS 5122 and VAG 1783
1
-
Side curtain airbag
5
-
Igniter
6
-
Airbag connector
7
-
Clip
Fig. 2 Disconnecting harness connector for side curtain airbag