A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
Clutch Master Cylinder: Service and Repair
Clutch Master Cylinder Removing And Installing
Special tools and equipment
- 3094 hose clamp
Removing
Caution:
-
Before working on the electrical system:
-
Determine the correct coding for the anti-theft radio.
-
Switch the ignition off (also applies when connecting the battery) Failure to do so may damage the Engine Control Module (ECM).
-
Disconnect the battery Ground (GND) strap.
To remove E-box from plenum chamber:
-
Remove bolts (arrows) and remove cover.
-
Remove Engine Control Module (ECM); if necessary remove 8-pin relay support, Refer to Wiring.
-
Disconnect harness connectors at connector station.
-
Remove engine wiring harness together with rubber grommet from opening in E-box.
-
Remove both nuts -A-
-
Lift E-box out at rear of threaded bolt and remove from mounting point -B-.
CAUTION: