A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
/Page-4433003.png)
-
Install bonded rubber bushing on both sides and perpendicular to hole in wheel bearing housing.
-
Position one 3293/3 thrust piece each onto two bushings and use threaded spindle to draw in bushing up to stop.
Fig. 4 Removing wheel bearing from wheel bearing housing
Fig. 5 Installing wheel bearing
-
If necessary, remove any corrosion/dirt from hole in wheel bearing housing.
-
Press in bearing -A- until fully seated.
