A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
/Page-4464002.png)
The drive peg of the drive gear -A- faces seal -B- and locates in the groove of the differential.
Retaining clips (arrows) locate in circumferential groove in differential.
-
Always replace seal -B- and circlip -C-.
-
Install drive flange using VW295 needle bearing drift.
-
Top off and check transmission oil level.
Tightening torques
Component ............................................................................................................................................................................................ Tightening Torque
Driveshaft to Drive Flange
M8 ......................................................................................................................................................................................................... 40 Nm (30 ft. lb.)
M10 ....................................................................................................................................................................................................... 80 Nm (59 ft. lb.)
Heat Shields Over Drive Axles on Transmission ...................................................................................................................................... 27 Nm (17 ft. lb.)
