A4 Quattro Sedan L4-1.8L Turbo (AEB) (1998)
-
Remove drive flange. To loosen securing bolt, thread 2 bolts into drive flange and counter hold using tire iron.
-
Place VAG1306 drip tray underneath and drain gear oil.
-
Remove drive flange at installed bolts.
-
Pry out drive flange seal using tire iron.
Installing
Installation is reverse of removal, noting the following:
-
Clean gasket seat.
-
Coat outer edge of oil seal with gear oil.
-
Fill gap between sealing lip and dust lip with multi-purpose grease.
-
Using 2062 driver, press in seal for left drive flange to stop without bending seal.