A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Assembly preparations for pulling in subframe bonded rubber mounts
-
Install installation device and insert 3372/2 thrust pieces.
Aligning bonded rubber mounts
-
Bonded rubber mounts must be aligned using a long rectangular tube or a straight-edge.
Angle -A-: 90° + 5°
Note: Always use protective jaws when clamping the subframe in a vise.
Pulling in rear bonded rubber mounts
-
Use G 294 421 A1 lubricating oil when pulling in bonded rubber mounts.
-
Pull in mount-A- until 3372/1 thrust piece aligns with upper edge of 3372 installation device.
-
Remove 3372 installation device and 3372/2 thrust pieces upward.