A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Pulling in rear bonded rubber mounts
-
Install 3372/2 thrust pieces between 3351/4 bridge and subframe.
-
Pull bonded rubber mount in up to stop.
Note: If the paint on the surface of the subframe is damaged, carry out corrosion protection measures.
Pulling in front bonded rubber mount
-
Use G 294 421 A1 lubricating oil when pulling in bonded rubber mounts.
-
Install 3372/2 thrust pieces into 3372 installation device.
-
Pull in bushing -A- until 3372/1 press tool is flush with upper edge of 3372 installation device.
Pulling in front bonded rubber mounts
-
Lift 3372 installation device and remove 3372/2 thrust pieces.
-
Repiace3351/4 bridge with 3351/1 thrust piece and then pull bonded rubber mount in up to stop.
Note: If the paint on the surface of the subframe is damaged, carry out corrosion protection measures.