A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
/Page-1248001.png)
Crankshaft Gear/Sprocket: Service and Repair
Chain Sprocket, removing and installing
Special tools and equipment
^
Sleeve 30-100
^
Two-arm puller, commercially available.
^
Protective gloves
Removing
^
Remove oil pan.
^
Removing front sealing flange.
^
Disconnect chain wheel of oil pump, remove chain tensioner and chain.
^
Pull chain sprocket off crankshaft with puller 2- (Use a suitable washer -1. to protect end of crankshaft).
Installing
Installation is carried out in the reverse order of removal.
WARNING! Wear protective gloves!
^
Heat chain sprocket in heating appliance for approximately 15 minutes to 220°C.
Note: Installation position: wide collar on sprocket facing toward engine
