A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
/Page-1292002.png)
^
Dowel sleeves for bearing caps must be located in cylinder head.
^
Seal joints Fig. 3 and Fig.4
5. Valve guide
6. Valve stem seal
7. Valve springs
8. Valve spring plate
9. Valve keepers
10. Hydraulic valve lifter
^
Checking
^
Do not interchange
^
Store with cam contact surface downward
^
Before installing check camshaft axial clearance
^
Oil contact surface
11. Intake camshaft
^
Check radial clearance with plastigage (hydraulic lifters not installed).
^
Wear limit: 0.1 mm
^
Runout: no more than 0.035 mm
12. Bearing cap for intake camshaft
^
Must be located on dowel sleeves
^
Dowel sleeves must be located in cylinder head.
^
Note installation position
^
Installation sequence
13. Double bearing cap
^
Must be located on dowel sleeves
^
Dowel sleeves must be located in cylinder head
^
Coat sealing surface lightly with AMV 188 001 02 before installation
^
Seal connections between double bearing cap and cylinder head Fig. 3
14. Exhaust camshaft
^
Check radial clearance with plastigage (hydraulic lifters not installed). Wear limit: 0.1 mm
^
Runout: no more than 0.035 mm
15. Bearing cap for exhaust camshaft
^
Must be located on dowel sleeves
^
Dowel sleeves must be located in cylinder head
^
Note installation position
16. 10 Nm
17. 10 Nm
18. Drive chain
^
Check for wear
^
Before removing, mark installation position
19. Camshaft adjuster
^
With solenoid valve for camshaft adjustment -N205-
^
Hold in position with retainer for chain tensioner 3366 before removing
^
Seal sides of joints between camshaft adjuster and cylinder head Fig. 4
20. Metal/rubber gasket
^
Before installation coat sealing surface lightly with AMV 188 00 1 02
21. Gasket
^
Always replace
22. Exhaust valve
^
With sodium filling
^
Note instructions on scrapping valves with a sodium filling
^
Do not rework, only lapping in is permitted
^
Valve dimensions Refer to, Fig. 1
23. Intake valve
^
Do not rework, only lapping in is permitted
^
Valve dimensions Refer to, Fig. 1
24. Sealing ring
^
For intake camshaft
25. Rotor for
^
Camshaft Position sensor
^
Note correct installation position: Insert tab in notch of camshaft
26. Washer
^
With cone
^
Note installation position
27. 25 Nm
28. Housing - for Camshaft Position sensor -G40-
29. 10 Nm
