A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Ignition Lock: Service and Repair
CAUTION!
Disconnect the battery Ground (GND) strap before working on the electrical system.
NOTES:
-
Before disconnecting the battery determine the correct coding for the anti-theft radio.
-
After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.) as
outlined in the Owner's Manual.
NOTES:
-
For removing, the lock cylinder always use the spare key or shop key with the flat plastic handle.
-
The master key equipped with a light and/or remote control transmitter in its handle is unsuitable for removal because the keys broad handle
covers an access hole in the lock cylinder.
Removing
-
Remove driver's-side airbag unit and steering wheel.
-
Remove steering column switches.
-
Insert spare or shop key and switch ignition on: access hole will appear in front of switch next to ignition key slot.
-
Insert length of steel wire or small screwdriver (approx. 2 mm dia.) as far as it will go, as illustrated, and pull lock cylinder out of steering lock
housing in direction of arrow.
Installing
-
Ignition switch must be in "ignition on" position.
-
Push lock cylinder with ignition key all way into steering lock housing and press in firmly until catch engages audibly.
-
Install steering column switches and steering wheel.