A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
-
Drive flange seal, pulling out.
Installing
-
Coat outer edge of oil seal with gear oil
-
Drive in new seal to stop, without canting.
Installtion position: The open side of the seal faces the transmission.
-
Install right drive flange
-
Install bolt for drive flange (arrow, 23 Nm) while securing drive flange against turning, using a drift.
-
Install drive axle, refer to Drive Axles, Bearings and Joints - Axle Shaft Assembly - Service and Repair - Procedures See: Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair
-
Install heat shield for right drive axle.
-
Checking oil level in front final drive, refer to Differential Fluid - A/T - Testing and Inspection - Procedures See: Front Final Drive
Fluid/Testing and Inspection
Tightening torques
Component
Drive flange to transmission ............................................................................................................................................................................... 23 Nm
Drive axle to drive flange M10 .......................................................................................................................................................................... 77 Nm
Driveshaft to drive flange M8 ............................................................................................................................................................................ 39 Nm
Heat shield for driveshaft to transmission .......................................................................................................................................................... 23 Nm