A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Control Module: Service and Repair
Removing and Installing
5 Speed Automatic 01V
Automatic Transmission Control Module (TCM) -J217-, removing and installing
Removing
-
Remove lower right A-pillar trim and right front door sill trim.
-
Detach carpeting from right inside door sill, and raise carpeting approx. 20 cm.
-
Unclip box at -A- by pulling it upward.
-
Unclip box at -B- as shown.
-
Unclip TCM from box (arrows).
-
Release catch on multi-pin connector and disconnect connector from TCM See Fig.3
Installing:
Install in reverse order of removal, with the following additional steps: